Easy Diy King Platform Beds With Storage
King platform beds with storage – is an elegant addition to any room. It can create some extra storage space by adding sweepstakes to the bed. These fit the platform and are very easy to add to your project. It will only take you a few extra steps to add a lot of extra space. The design of your bed. Measure the size of your mattress. Determine the number of drawers you want. Three on each side will work. A double will only have a series of drawers. In addition to measuring how high you want the platform to be. Construct the bed frame for the drawers. Start by making a one piece MDF cut of the length of the bed and the height you want your deck to be.
Then cut the board to make the top and bottom king platform beds with storage frame piece. Screw these into the center piece. Cut cross-sections to be connected to the center piece of the support mechanism. The drawers will go between each of the sections. You will have two on each side of the stocking. Screw in place. You will stagger joints slightly to connect them. Attach the drawer tracks over the cross-section pieces. Screw the lower MDF piece into the frame with an electric screwdriver. Put screws for each of the corners and between one to two feet away along the frame. Turn the bed one and screw the upper part of the MDF board into the frame. Sand and stain boards.
Build your drawers using an MDF iron. The drawers must have one bottom piece and four sides. Sand stains and adds a handle on the front of the drawers. The size of the bed will determine the depth of the drawers. Make the drawers about an inch smaller than the openings in the bed drawers. Place the runners into the drawers and then attach them to the tracks inside the bed. Put the drawers in place. Place the mattress on the top of the king platform beds with storage.